Select the wavelet with which to work. Clear Show all wavelets if you're already working with the desired wavelet to increase the work space in this dialog box.

Type a name with which the wavelet is identified in the main synthetic display.

Select a predefined filter to apply to the wavelet selected in the display pane. Controls to specify the cut and pass frequencies appear below based on your selection.

Select the mathematical transformation used to explain the data.

Type the display amplitude of the trace data.

Select the source curve and method to use when creating the AVO logs. Click Create AVO Log suite to create numerous types of logs to use in AVO analysis.

Select whether to display simulated first order multiples alongside primary reflections, or to just display multiples and not the primary reflection. First order multiples are the first reflection of a primary reflection.

Type the maximum percent for the reflection coefficient below which multiples are not shown. GeoSyn calculates the maximum reflection coefficient in the model, uses a percentage of that, and ignores all reflection coefficients less than that.

Type a value for the automatic gain control.

Select the Apply check box and then click Edit to display the Noise Parameters dialog box, where you apply noise type.

Click Edit to display the Wavelet Properties dialog box, where you change wavelet and spectrum properties.