Type the total number of traces to display in the time model. This number affects the depth model if you selected a value in the Trace overlay every drop-down list in the Display Parameters: Depth Model tab. It also affects where you can place a well on the depth page because a well can only be placed on a trace.

Type the number of times to copy the non-interpolated trace from each well. Copies appear alongside the existing non-interpolated trace. Click color to change the color in which duplicates appear. To highlight non-interpolated traces, click Highlight well traces.

Type the range for the vertical scale. When the time model isn't flattened, the top of the model is zero, when flattening is on, the flattened correlation is zero.

Type the number of traces per running unit for the horizontal scale, and the number of units per second in the vertical scale.

Select whether correlations drawn on the depth page appear. Correlations deleted on the time page are also removed from the depth page.

Select a correlation upon which to flatten.

Select whether to display well logs on top of the seismic cross section.

Select whether to display a trace overlay and whether the trace shows velocity, wiggle, or transit readings. Clearing this check box and selecting the Underlay check box below helps you detect washouts.

Type the display amplitude of the trace data.

Select whether to display a color fill then click Edit to select the colors to use and whether to display a color bar reference to the right of the model.

Select whether the color range is based on the minimum and maximum values inherent in the model or based on minimum and maximum values you type.

Select common customizations.

Click Font and specify the display properties for trace information that appears above the model adjacent to the logo.

Select whether and the frequency with which timing lines appear.